Nice Stanley No.79 side rabbet plane. Lightly used condition. Some light rust staining on the cutters. They look like they have never been resharpened. Nickel plating looks to be 100%. Thanks for look

 

hello up for bids one lot misc, measuring inspection tools some antique. all indicators work may need cleaning and calibration. good starter set. please note all sale are final thanks and happy biddin

 

I am selling a used original Plomb 5449 1/2'' ratchet. It is in good working order. Pebble finish. Selector will go too far to either side but if kept in normal operating areas works fine. It is a 60

 

For auction is a vintage Craftsman pocket level.It has a metal exterior and is 5" inches long.Works as it should and looks to be in nice condition for the age.Thank you for looking!

 

A Snap-On --CJ92 Battery Terminal Puller in Good Condition. Great for pulling battery terminals without damaging them and also can be used for other purposes.

 

Estate sale find. Up for auction is a nice Stanley No 53 7oz Hammer. As you can see from the photos, this hammer has been well maintained. Some of the original decal is still intact. The head is firml

 

Atha Stanley Flatter Hammer Blacksmith Anvil Forge Tool Roughly 2- 3/4" to 2-7/8" Square Flatter Hammer. The hammer's face does have marks from use. The edges do have marks. Head Overall length measur

 

. Attention! I only ship to Paypal Verified Addresses. Sorry, just following the Paypal rules for Full Protection... Measures 8 1/4" long. Great condition, a little greasy. Marked "Blue Point CF-7A, K

 

VINTAGE MISC. B & D HOLE SAWS & MANDRELS. (26)SAWS & (6)MANDRELS. ALL IN VERY GOOD CONDITION. MANY APPEAR UNUSED. MANDRELS IN VERY GOOD CONDITION. NO PREVIOUS OWNER MARKS.

 

EXCELSIOR 6 LEVER PUSH LOCK PADLOCK (LOCKED.....NO KEY) Lock is in locked position. and there is no key. Measures approximately 3 1/8" wide (as pictured) x 2 1/4" wide. Has wear including surface mark