Large cooper's 'CROZE' for making barrels, This is a specialised tool, used by coopers in barrel making.The tool cuts the grooves in the ends for the round head to fit into.The cutting is done by a un

 

Bernz No. 1 Blowtorch – This center-feed, quart-size, bottom-fill gasoline blowtorch was manufactured by the Otto Bernz Co. of Newark, New Jersey. The No. 1 differs from the No. 3 Blowtorch only in

 

Vintage boxwood and brass Button Maker's caliper rule No 1461. 3 inch rule marked with brass caliper slide in 1/40ths of an inch. The edge of the rule is marked J Rabone & Sons, so it predates the

 

YANKEE No. 41 drill, screw driver, with 10 bits, shows some wear and light rust on finish, works smooth Returns accepted email questions

 

This is a set of KEEN KUTTER Brace Bits in box. The box has a label inside that is marked Set A Simmons Hardware Co. The bits in the box do not match the label.The bits are numbered 4, 6, 6, 7, 8 &

 

Offering one new S&G single nose Deposit Box lock with original key. This is a S&G model 4110 series lock designed to be rekeyed to a new key without opening the lock. See patent #: 4,462,230

 

Bernz No. 7 Self-Acting Torch / Blowtorch - This little self-acting, 1/4-pint gasoline blowtorch was manufactured by the Otto Bernz Company of (I believe) Rochester, New York. I say “I believe” be

 

For your bid this Millers Falls Smoothing Plane No.90CBG with the Corrugated Bottom.Sole about 9" long,cutter is 2 ".Excellent condition & ready to use.Free US PM shipping.Never a reserve. If you

 

Vintage Pipe Wrench/Strap wrench Ridgid No. 5 from Ridge Tool Co, Ohio Belt is 1 3/4 Inches Wide Wrench is 17 1/2 Inches Long Old tool, has been used plenty, but still in good and usable condition. Ma

 

VINTAGE SKATCHET SURVIVAL HATCHET SKINNER HAMMER MULTI TOOL SHEATH HAS AGE WEAR WITH SCRATCHES / SCUFFS / NICKS/ STAINS / TARNISH ON RIVETS / SOILTOOL HAS AGE WEAR WITH LIGHT RUST / SPOTTING / SCRATCH