HARD FLAT STEEL ANVIL

 

3/16" X 8-1/2" and in good shape..Ask any questions and i'll give you an honest answer.Happy to combine shipping.Will ship to Canada-U.K-Australia-Japan and most places.Will refund if i misrepresent a

 

4 vintage Buck Brothers wood carving chisels in poor condition. The 2 smaller ones need sharpened and the 2 larger ones need new ends ground on them. The handles are good with some carved initials on

 

Fancy C19th. 24 Inch Two Fold Brass Ruler by John Rabone & Sons Birmm. With decorative hinge plates and only one slot disc retainer. This is a vintage 24" J. RABONE & SONS - BIRMINGHAM ENGLAND

 

2 old leather cutting tools makers name on both is Karl Leister one is older than the other. the brass ferrule on one of them is a bit crushed inward. see pictured.

 

Very Old, very dirty lead hammer mold, approximately 8 inches long,Chas E Field Providence, Rhode Island,

 

THIS MACHINIST LEVEL IS USED BUT IN GOOD CONDITION.THIS LEVEL WAS MADE IN USA IN NEW BRITAIN CONN. THERE ARE A FEW SURFACE RUST SPOTS ON IT.IT NEEDS A GOOD CLEANING AND THERE IS NO NICKS ON IT.

 

Up for grabs a egg beater Millers falls co hand crank drill Greenfield mass made in USA #70 with rose wood handle screw top compartment plus 8 Drill bits works excellent a little tight overall conditi

 

5/16" wide paring chisel by Mathieson This long firmer type paring chisel was made by Mathieson.Blade clean, Reground and honed, ready for use.The blade is 5/16" wide, Overall length 13".Fitted with a

 

Rare Vintage Small Hand Axe Ax with Crown Logo vgc Old Tool Click Images to Enlarge You are bidding on a vintage and rare Small Hand Axe Tool with Crown Logo in good clean, as shown condition. This ca