Four 14 ounce cast aluminum mugs shaped like a 12-point socket. New in box, but box is not perfect (one crimped corner and general wear).

 

VINTAGE ORIGINAL 2N 8N 9N FORD TRACTOR 01A-17017B M41 TOOL KIT WRENCH. This is the Sparkplug and Headbolt Wrench that was a part of the original tool kits for the 2N, 8N, 9N Ford Tractors. The Wrench

 

Replacement 2" stones for any cylinder hone using cotter pin mountings. Stens 750-380, KD 302975.

 

Measuring about 3¾" top to bottom when closed, and about 2¾" across and ½" thick, this heavy duty padlock has a working brass key and also comes with the two pieces of door jamb hardware that are s

 

A NICE OLD ATKINS 14" BACK SAW IN GOOD CONDITION. BLADE DOES HAVE MILD RUST BUT TEETH ARE ALL GOOD AND SHARP. HANDLE IS GOOD. NO CRACKS, SPLITS OR BREAKS. LOGO CAN BE SEEN BUT IS VERY LIGHT. ANY QUEST

 

Marshall-Wells Double edge axe, Marked Zenith with star above it.Marshall-Wells, a couple in middle that I can not make out and 31 on back. Head has a couple scratches on back side and a few nicks aro

 

This machinist's level is early (pre-1907), rare, and struck with the "C.F. Richardson" "Athol, Mass" trademark. It retains ~70% or more of its original japanning and bears an uncanny resemblance to a

 

8" - 9.5" Purchase and ShippingI describe the condition as accurately as possible in the item description however please keep in mind that descriptions are subjective, the item you see is the item you

 

Payment by palpal only. We have here an Old "ALLEN" Compression Tester. The instructions are marked 1-42. And the newest vehicle on the Compression Test List is 1942. So it is probably safe to assume

 

HELLO FOLKS! HERE FOR YOUR CONSIDERATION IS: AN ANTIQUE STANLEY BEVEL SQUARE. IT IS MARKED; STANLEY ON ONE SIDE. AND MARKED U.S PAT. 7-14-08 (JULY 14, 1908) ON THE BACK SIDE. IT HAS THE ORIGINAL THUMB