<>TWO STEEL KEY MOLDS/STAMPS<>I have two steel key molds,stamps or dies from a locksmith's collection..The largest one is is 1-3/4"X1-1/4" and 7/8" tall and weighs 3/4 pound..The embossed

 

use plumbing tools

 

THIS ITEM WILL SHIP FOR FREE This auction is for a NEW - MADE IN THE USA - Bright Star, RESPONDER (Right Angle) FLASHLIGHT, Yellow, ALKALINE VERSION, #500305 All details are from the Manufacturer's pa

 

This plane un cleaned, is marked on one side Stanley, on the other side is No. 78 made in U.S.A., marked at the top of the single blade is Stanley, with their S.W. Sweet Hart logo, made in U.S.A., it

 

5 Stanely chisels (1/4", 1/2", 3/4", 1", 1 1/2"). Nice clean set of chisels. Backs have been flattened and have a mirror finish. Freshly sharpened (25 degree primary, 2 degree micro bevel). Razor shar

 

Up for Auction is a Vintage Cant Hook. It had belonged to my Grandfather, he had used it many years ago when he did logging. The handle is 42 1/4" long. It has some wear at the top of the handle and a

 

I DO NOT SHIP INTERNATIONAL. ALL PAYMENTS MUST BE RECEIVED WITHIN 7 DAYS OF THE END OF THE AUCTION VIA PAY PAL ONLY A vintage pipe vise in good condition. Chain is flexable, will take up to 2 inch pip

 

USA SNAP ON F830 Ratchet 3\8..Used but still in nice condition..The best tools on the market..Shows normal wear but still a nice piece..Q's please ask..Delivery con.# will be included..Good Luck To Al

 

UP FOR BID I HAVE A PLUMB DOUBLE BIT AX HEAD. THIS HEAD MEASURES 9 7/8" LONG, IT HAS 4 3/8" BLADES. BLADES DO HAVE SOME CHIPS (SEE PICTURES) THERE IS SOME MINOR PIN PRICK PITS. DOES HAVE A NICE DEEP P

 

Lot of misc machining cutting tool bits and tool holders for use in a lathe. This are vintage/antique parts from a machinist's tool chest from the 1940's. The bits have no markings, however one of the