This is a double bit axe head that is free of wood and in excellent condition with no visible makers marks and looks to be very well made. The head is 10 7/8" end to end and 4 5/8" across axe bits and

 

Vintage Antique Small Diamond Calk Horseshore Co. Diamalloy Steel 4 Inch Adjustable Wrench with 5/16 inch Box Wrench on the End - No Reserve. It measures 4 1/4 inches long and opens up to a little ove

 

Template CDGPNK2 Description used.Blacksmith name. ---銘秀（akihide）Width of the blade : about 24 ㎜.155g.It is a laminate blade. It has rust. because old it has a dirt.Please sharpen before use

 

For your consideration is a sway back Keen Kutter hand saw with a nice straight plate with no rust or pitting. The etching is only partially visible as the saw is stained with age. Various saw makers

 

&amp

 

Please read the entire description before bidding or paying!! Failure to do so may cost you some money! For your consideration is this old Brass torch that My Dad has had for a long time and he even p

 

This auction is for a vintage Cleveland Twist Drill Co. multi-point gauge. Some of the writing is inked in red, overall in very good condition. Please don't hesitate to email me if you have any questi

 

Replacement 2" stones for any cylinder hone using cotter pin mountings. Stens 750-380, KD 302975.

 

Here is a VINTAGE LEVEL that I believe is made of BAKELITE. It is 4 3/8" LONG and in GOOD CONDITION with some wear but no damage. It appears to be accurate and was made by the GARRARD COMPANY in ENGLA

 

Iam selling this out of a tool box I bought here is all the info I found good luck bidding.This is what I found I dont now which one it is I put alot of picture for you to figure it out . I dont now a