This listing is for a Philadelphia Tool Co. carpenter's hatchet head. This is a older company that was later bought by Plumb. This head does not have any personal markings but does have scratches and

 

VINTAGE IRON MONKEY WRENCH 5.5 INCHES TOP TO BOTTOM - 2 INCHES SIDE TO SIDE AT TOP - 1.25 INCHES WIDE AT BOTTOM. STAMPED ON TOP: PAT SEPT 7 17. MISSING SCREW TO KEEP OPEN OR CLOSED. PLEASE READ THE FO

 

Nice vintage Stanley plane, No. 45. In good condition.

 

you will be bidding on a vintage set no.5 drill bit holder made by THE STANDARD TOOL CO. of cleveland ,ohio,made of cast,has 29 holes,1/16 to 1/2",in good condition for its age,does have some age crac

 

One #110 is lightly used and still has partial Stanley Tools sticker on handle. The other is broken off on the back. The 220s are in good shape, one has tarnish on the plane as shown. They all need a

 

I like No. 65 Block Planes, and this is a good one with a Sweetheart Buckle Cap and a good Sweetheart iron. Somehow I keep gathering 65's up. I think they are multiplying in the plane cabinet when I a

 

Large Framing Mortising Chisels Include 1/2" Mortise and 1/8" Mortise Corner.

 

RARE MINT "ATHA" Half Round Hot Cut Hardy.. Here is a chance that most small anvils owners dont get very often ... This is a MINT N.O.S. ATHA half round Hot Cut with a factory small 1/2" hardy shaft..

 

FOR AUCTION I HAVE LOVELY VINTAGE PADLOCK. THE PADLOCK IS APPROX 103MM LONG, COUNTING THE LOCKING ARM, AND COMES WITH WHAT LOOKS TO BE THE ORIGINAL KEY. THE LOCK LOOKS TO BE IRON, WITH BRASS RIVETS AN

 

Medium grit natural oilstone, clean and flat, in pine box This is an unusual natural oilstone.Not one I'm familiar with, pale yellow in colour, medium/fine grit, sandstone type material.Non standard 8