A pre-owned vintage wrench tool lot, includes snap-on mac and other brands, of note is an interesting bridgeport X wrench set. All have seen previous useage, include scratches scuffs id marks corrosio

 

Hello, You are viewing a listing for an antique Sargent Cylinder Rim Night Latch. Admittedly, I do not know much about latches, so i photographed the complete contents on the box and the packaging for

 

Some of the paint has worn off and there are spots of rust. It is 3 1/2" long on the bottom plane. 5" long from back of handle to front of plane. If you have any questions about this item please conta

 

Antique Ball Peen Hammer 1 1/4 lb My Dad's hammer from back in 1930s or 40s

 

has very good patina collectable

 

UP FOR AUCTION Legitimus Collins & Co. Machete NO. 460 w/ Sheath SCABBARD NO. 13 IT IS USED. IT DOES HAVE SIGNS OF WEAR. IT IS MARKED ON THE BLADE AND ON THE SHEALTH. THE SHEALTH IS SPLIT ALL THE

 

PAYMENT METHODS ALLOWED ARE PAYPAL (TO CONFIRMED U.S. ADDRESS ONLY) AS PER EBAY RULES. ALL PAYMENTS ARE DUE WITHIN 7 DAYS OF THE END OF AUCTION. NO EXCEPTIONS!!! WE DO NOT SHIP OUTSIDE OF THE UNITED S

 

this jig has minor surface rust that can be cleaned off with light rubing with 440 grit paper then keeping them waxed. comes with the 5117 1/2 " Half-blind DovetailTemplate

 

Antique WHITMAN & BARNES #73 open end wrench - 7/16" & 1/2". This is a nice, quality tool made in U.S.A.. Side one: stamped W&B, MADE IN U.S.A. on one end and 73 on the other end. Side two

 

In this auction you are bidding on : .....VINTAGE SNAP ON TOOLS HEX RETHREADER DIE SET.... Made by SNAP ON TOOLS, USA. Snap On Tool Number TRC-7A. Comes with 7 different Dies. 5/8-NC, 9/16-NC, 1/2-NC,