VINTAGE CRAFTSMAN AUGER BITS ASSORTED LOT OF 15 PIECES. MADE IN USA MADE IN USA. MOST OF THE BITS WERE MADE BY CRAFTSMAN ALL BITS IN GOOD CONDITION. CRAFTSMAN 16/16''12/16'',11/16,10/16'',CRAFTSMAN NO

 

Your bidding on an antique oak machinist tool chest. Has 11 drawers,nichel plated corners and five latches. No brand name,the latches are Eagle Lock Co. and the lock is Yale. Measures 20" tall X 9 1/2

 

packercitydeals store Your browser does not support JavaScript. To view this page, enable JavaScript if it is disabled or upgrade your browser. Click Here. Double your traffic. Get Vendio Gallery - No

 

SEARS CRAFTSMAN TOOLS NUT CRACKER BUSTER SPLITTER REMOVER REMOVAL TOOL Please email with any questions prior to purchase. Thank you

 

A 5 inch tall hand vise with jaws that are 1 1/2 inches wide. The spring between the handles has broken off so you have to manually open it. Other than that it is a good user. Handy for holding smalle

 

This machinist's level is early (pre-1907), rare, and struck with the "C.F. Richardson" "Athol, Mass" trademark. It retains ~70% or more of its original japanning and bears an uncanny resemblance to a

 

Up for auction is this vintage hatchet/hammer. The piece is in pretty good used condition, minor surface rust and a few small chips on the edges, you can probably see them in the photos. The piece is

 

THIS AUCTION IS FOR A VINTAGE RARE UNUSUAL HELLER BROS BLACKSMITH HAMMER IT IS SIGNED HELLER USA AND HAS THE HORSE LOGO,IT WEIGHS 2 POUNDS IT MEASURES 4 3/4 INCHES LONG THE END OF THE HEAD IS 2 1/2 IN

 

A large grouping of keys, some antique, some vintage, some locks for desk drawers/doors, some file cabinet key/lock sets and a sliding glass door key/lock set. Some of the names on the keys are Diebol

 

Time to clean out some of my Delta Milwaukee-Rockwell-Homecraft USED Parts and Goodies I have had around for years. More To Come.....Keep watching for Delta woodworking and Machinery Parts over the Ne