I RECEIVED A MESSAGE THAT THIS IS A VALVE ( TUBE ) RADIO.GLASS VALVES AND TWO BATTERIES~~NUMBERS IN THE BATTERY CASE ARE 50B-71061~~~273619~~RC/19B24917PLEASE LOOK AT THE PICTURES.NICE CONDITION.THE B

 

VINTAGE OAK WOOD TELEPHONE RINGER BOX. I KNOW LITTLE ABOUT BOX EXCEPT IT APPEARS COMPLETE AND IN GOOD CONDITION. THE HAMMER AND RINGER STILL INTACT AND CRANK HANDLE FREE AND ENGAGES WITH THE GEARS. ON

 

Here we have a Victrola Number 2 phonograph reproducer. It is in very nice original condition. It has had no tinkering or rebuildimg! The metal is as shiny as if it were new. They don't come any bette

 

Early Western Electric Hand Held Telephone Receiver Handset. Measures 10 by 5 by 3 inches. In good condition, some light surface pitting on metal. A small screw that goes through the bake light is mis

 

Sweet lot of two globe shaped audio output tubes from Cuningham. Both have engraved tight bases. Checked strong on my stingy Jackson tester. No shorts or leakage detected.Results of 95% and 101% were

 

Vintage Bell Systems Western Electric Beige Dial Princess Phone. UNTESTED. Has some light scratching here and there. Has some scotch tape residue on front which can be cleaned. This is UNTESTED as I d

 

Measuring approximately 1 1/2" across the base, 1 1/16" across the face, and 5/8" tall, this lot of 1920's era radio equipment knobs are in very fine used condition. Equipped with set screws for insta

 

You are looking at a Victrola Motor that has a damaged spring. It came from a Victrola I purchased some time ago. Would be a great project for anyone able to repair it. Or for just parts. I will start

 

This GE ( General Electric ) 13 Transistor AM/FM Battery Portable radio is as I received it from an estate. I did not find any model number on the radio. I think it is most likely from the mid-to-late

 

Found (3) phones from an estate sale of an older NY Bell system installer. He just saved a few from his early days and I could afford to buy (3) of them. I am not a phone collector so please see pics