A vintage/original UK Rola Celestion Ditton 66 Hi-Fi Studio Monitor Speaker Mount/Mounting Screws-Clips-Hardware Lot x 11. Just removed from an original cabinet dated 1977. Visually they appear to be

 

There are over 200 various different makes, models, and sizes of vacuum tubes. I do not know if they work I didn't check them just cleaning out some of the stuff at my Grandfather's house. Will ship o

 

Rogers LS3/5A - classic & legendary BBC Monitors - Rare 15 Ohm "White Belly" version in Black Ash!! These are perhaps the finest monitor speakers ever made! Here you have the chance to aquire some

 

Great condition. Could probably use a wipe-down though as to normal dust accumulation. If payment is received before 2pm EST, will ship same-day. - Vintage McIntosh CR8 Remote Area Controller- The CR8

 

These tubes are used and tested good on a Heathkit IT 21 tube tester. The test reads as a percentage with a good tube range of between 58 - 100 %. These tubes had the following % readings Philco type

 

Antique loudspeaker horn with TruTone brand. Horn is not metal (except for tip at bottom) and appears to be made of paper mache. Glossy lacquer paint on inside of speaker. There is a small hole, appro

 

TUBES ARE FROM A TV REPAIRMAN'S TUBE CADDY. UNTESTED, SOLD AS-IS. PN'S: 0B3, 1N2, 3EJ7, 5AM8, 5DJ4, 5KJ6, 6AL3, 6AT8A, 6AV5GA, 6BC5, 6BE6, 6BQ6GA/6CU6, 6DL3, 6HL8, 6HS8, 6HZ6, 6J6A, 6LT8, 6LU8, 6SN7GT

 

You are bidding on a Marantz 6200 Working Turntable Needs New Belt GREAT Condition. This Item is Good Condition Need New Belt . It does however need a belt. While I was testing this unit the belt brok

 

You are looking at a very nice, strong matched pair of Amperex Holland short plate ECC83/12AX7's with small halo getters and copper grid posts. The logos and printing are gone but these are identical

 

UP FOR AUCTIONIS ONE ONE INCH THROATJBL 175 DRIVER WITH A 1217 - 1290 JBL HORN AND CHROME END PIECE WITH MOUNTING BRACKET BUILT INTO THE HORN WITH MOUNTING SCREWSAND BOTH RED JBL SEALS THIS DRIVER SOU