This is an old Heller Bros Cross Pein hammer it weighs in at about 2 pounds. My scale is not that accurate. The faces are used and un messed with, markings are not sharp. In addition to the Heller Bro

 

You are bidding on 2 outside calipers - 5" (Union Tool Co.) and 3 3/4" (Goodell Pratt Co.). The small caliper's look like the pivot screw has been replaced. They are clean and in good condition.

 

Antique wooden moulding plane Makers mark is Robert Wooding Plane measures 9 1/4 Inches, so it has possibly been cut down. Unsure if the wedge is original. Needs cleaning up. email with any questions.

 

UP FOR AUCTION VINTAGE MACHINIST TOOLS. DUNLAP & GENERAL PROTRACTORS, DOUBLE END DRILL BITS & MILLS , SOME COULD HAVE A BROKE END.SARGENT DIVIDERS ( MISSING LOCK SCREW). HOLE GAGES, PARALLELS

 

Both are in very good / never used condition. The boxes have a few scratches and some wear as shown in pictures.

 

GENUINELY SCARCE, ORIGINAL 1890 BLACKSMITH EQUIPMENT CATALOG. This wonderful 19th century circular was published by the P. H. & F. M. Roots Co., Connersville, Indiana. Established in 1859, the pio

 

You are bidding on 2 sliding breaker bar ratchets. Both in good working condition. The chrome is chipped off slightly on the 1/4" drive, but the 3/8" drive does not have any chips. There is an engravi

 

Vintage Wards Master Quality Broad Hatchet Axe Head Tool Up for auction is this nice used Wards Master Quality broad head tool. Measures 6" long by 4 1/2" on the cutting edge. Weighs 2 1/4 lbs. See al

 

Early No.38 Adze head: W.P (Ward & Payne - Sheffield)Actual weight is 1.65kg. Length is 9&1/2".Blade width 4&1/2"No visible chips or cracks - mainly usual pitting. ** See my other vintage

 

New never used mini snap on tool box. Perfect for small stuff or to display in a man cave. This was a very limited expensive give away from snap on and not many were made. This one is like brand new.