Up for auction is this hardy. This is a 3/4" x 4" rounding swage for an anvil. The inside rounding surface diameter = 3/4". This is a cast steel piece from ATMA Tool Co. Please see photos to rate cond

 

Lot of misc machining cutting tool bits and tool holders for use in a lathe. This are vintage/antique parts from a machinist's tool chest from the 1940's. The bits have no markings, however one of the

 

Galv tin patterns don't know much about them except hard to find ,of great interest , make up your own mind.

 

Vintage Flashlight RAY-O-VAC Baby Bullet Chrome Finish Vintage Flashlight RAY-O-VAC Baby Bullet with Chrome Finish. Used condition and 5 ¼” tall. Please look at pictures for condition and contact m

 

2 old leather cutting tools makers name on both is Karl Leister one is older than the other. the brass ferrule on one of them is a bit crushed inward. see pictured.

 

LUFKIN No. 511 Depth Angle Gage Gauge & 6" 2340 Rule Machinist Tool - Free Ship! Move mouse over images to see enlarged version Click to open supersize image This Lufkin tool is clean, without any

 

Vintage Cast Iron Stanley Wood Scrub Plane No. 40 Plane belonged to my grandfather who passed away in 1972. I don't know dating of plane, but he would have used it anywhere from about 1920 until the m

 

In very nice original condition with no missing parts. There is no makers mark on them. Please see the photos for details on this very old set of calipers.

 

Good condition blacksmithing hammer. Head is 4.5" in length. Top of head to bottom of handle measures 15".

 

*** SNAP-ON #HEX REHTHREADER TAPS AND DIES *** This auction is for a used Snap-on TRT60F hex rethreader taps. Also included is the TRF7B hex rethreader dies. NOT complete. Some wear. All items are as