HELLO THIS IS AN OLD ADJUSTABLE WRENCH IT IS MARKED WITH AN I-H RUSTY BUT IN GOOD WORKING CONDITION THANKS FOR LOOKING

 

ODD UNIQUE Cross Patter "V" Groove Hardy... Here is a odd type of hardy that was possible made for a specific use.. The Grooves show very little wear if any at all, they measure approx 1/4" wide.. The

 

FROM A ESTATE SALE SOME TOOLS MAY HAVE OWNER MARKINGS. good working lakeside butt gauge with box.. THANKS FOR LOOKING AND BE SURE TO CHECK OUT OUR OTHER LISTINGS AND OUR STORE! WE WILL COMBINE SHIPPIN

 

Mismatch of good tools. Total of 17 pieces snap on consist of 6 pieces; 1/4" Snap on Rachet MIDGET M-70L (handle repaired excellent) 3/8" Rachet F730 (missing reverse lever) 1/4" speeder handle 1/4"x

 

Vintage Stanley router plane no. 71. Based off of the picture in the directions it is complete. Has box which is in bad condition and the directions sheet. Has spots of rust (especially on two of the

 

11 SMALL SCREWDRIVER'S ,OLD CABINET OR JEWELER'S SCREWDRIVER'S ,10 ARE OLD WOOD HANDLE 1 ALL METAL ,2 ARE DARAIKE GERMANY , 1 IS BRIDGEPORT HWDE. USA , LONGEST IS 4 5/8 IN. SMALLEST IS 3 IN. LONG ,A F

 

Great Primitive "user"...

 

Up for Auction is Vintage Ford 9 inch Mechanics Wrench circa. 1920s - 1940s. This wrench has been used and still has good knurl and gear threads. There is some wear to the moveable lower jaw. The jaws

 

THERE IS A SLIDE BAR TO THE RIGHT OF THE PICTURES THAT YOU CAN SLIDE DOWN TO SEE ALL!   I accept Checks but I prefer Paypal.  Thank you for bidding and good luck You are about to bid on aRARE VINTAG

 

RARE OLD BRASS PADLOCK, "A & R DEBEAURAIN Frères", (MADE IN FRANCE). (Good functionning and key). Metal: Brass. Dimensions: Diameter: 8 cm. Height : 11,5 cm. Tickness : 1,4 cm. Weight: 350 gr. (P