This auction is for a vintage (5 lb.) spool of NASSAU Solder (Western Electric). It came from the original case it was delivered in over 40years ago & is in wonderful condition; a truly rare find,

 

This item is a used Triad filament transformer model F-22A. The specs are 6.3 VAC at 20A with a center tap. It has been tested and is in working condition. With the center tap, it would be a good tran

 

These tubes are used and tested good on a Heathkit IT 21 tube tester. The test reads as a percentage with a good tube range of between 58 - 100 %. These tubes had the following % readings Philco type

 

This auction is for a Vintage GE Communications 12AX7 Tall Plate Yellow Tip Preamp Tube. It has tall gray plates, a heavy duty thick top round getter and is in good clean condition. This is a used vin

 

LOT 17 NOS TUBES AS SHOWN, SOME TOPS OF BOXES REMOVED,

 

1 - Vintage Jensen 15" Speaker C15N 8 ohm Rated at 50 watts when new Original Ribbed Cones #3015910-H1 Codes 220310 = 1963 Tested and sounds great Ask any questions before buying Sold as-is S&H $2

 

This is an Elac Benjamin Miracord Turntable model 40A a belongs to my Stepfather and selling it now because I don't have room for it. It has been keep in storage inside the house for many years. The t

 

This is in very good working condition. My husband put a battery in the radio, and the batteries inside the amplifier and it worked!!! This is all in very good condition but there is one chip to the b

 

This is a Niles DPS-1. With it you hook up two amps/receivers and one pair of speakers. I used it with my surround system and an older Pioneer receiver. Takes 350 watts, up to 14 gauge wire. Downsizin

 

HERE IS A NICE PANASONIC RF-888JB RADIO GX-300. TESTED AND WORKING WELL. I CLEANED THE CONTACTS INSIDE WITH CONTACT CLEANER. IT WAS EASY TO DO AND MAKES A BIG DIFFERENCE WITH THESE RADIOS. THERE ARE A