Lufkin no. 781 folding boxwood rule good vintage condition as shown. folds out to 24" Check out my other items!

 

Bridgemaster Angle Gauge for Tablesaw

 

Vintage Cast Iron Lead Melting Pot About 6 1/2" in Diameter. Any questions just ask Thanks for looking

 

NICE 1/2" CHAMPION Bottom Fuller Hardy.. Here is a nice barely used bottom fuller that is work ready.. The fullering radius is clean with no wear, measures 2 1/2" wide with a 1/2" radius.. The hardy s

 

2 Very nice PETERSEN vise grips. Will gladly answer any questions or add photos. Shipping will be combined if possible to lowest cost for additional winning bids.

 

ESTATE SALE FIND-----13 PC. STUBAI CARVING CHISEL SET---NEAR MINT CONDITION--MOST LOOK UNUSED--IN THE ORIGONAL VINYL ROLL--A VERY HIGH QUALITY SET---PLEASE STUDY ALL THE PICTURES AND JUDGE FOR YOURSEL

 

Welcome to my Auction. Up for bid today is a Key-Bak key chain holder..made in U.S.A. The round holder has an approximate 2-inch diameter x 5/8-inch thick (including belt loop)...this has a 23-inch ch

 

2 pound, custom handle very tight fit and very sharp!

 

Little Giant Power Hammer Swage Block has three different size swages in one block. In good condition with some wear from use. Used in a 25# Little Giant Power Hammer. Could be held in vise or make an

 

From the tool box of an old time LA auto mechanic here is a lot of 6 pre 1948 Plomb 12 point double end offset box end wrenches. They are: # 8180 3/8 X 7/16, # 8181 1/2 X 9/16, #8182 5/8 X 11/16, 8183