THIS AUCTION IS FOR A USED WOODWORKING CLAMP, MARKED: WETZLER CLAMP Co. IS IN GOOD CONDITION WITH FEW RUSTED AREAS, NO CRACKS, CHIPS OR DENTS, 10" CAPACITY, 3" THOAT. Only Paypal is accepted for payme

 

WELL THEY SAY A PICTURE IS WORTH A THOUSAND WORDS. WELL THESE PICTURES DON'T DO THIS PLANE ANY JUSTICE. Well up for auction this week i have a Stanley # 79 side rabbet plane. I believe this is a type

 

Lot #2 (40) antique keys that all fit over a pin in the lock

 

This auction is for a Stanley No. 9 ¼ block plane. It is in good condition with no damage or repairs. The bottom of the plane is 6 ¼ inches in length. The blade is 4 ½ inches in length. Item will b

 

2 STANLEY CROW BAR'S , PRY BARS , NAIL PULLERS , CRATE OPENERS , BOTH ARE NO. 1460 ,BOTH ARE AROUND 17 1/2 IN. LONG ,BOTH ARE IN GOOD USED CONDITION.

 

This is for this antique billhook as shown which is well marked by maker as you can see.This does have a couple of chips in the blade but easy to grind out and this is still very solid and well made.T

 

I will be selling a lot of hard to find old and antique logging related tools and axes thru out the next month or so until I run out. All from the Great Pacific Northwest logging country. It is gettin

 

nascarmb28 Store Vtg Military U.S. Coast Guard Hammer Small Hand Sledge 3 lbs Engineer Tool Vintage U.S. Military Coast Guard 3 lb hammer. Marked U.S. and C2 on bottom of hammer. Hammer is tight and i

 

This is a Disston D-8 hand saw that is just over 28" in length and has 6 teeth per inch. The blade is rust free and has no bends or kinks. Tha handle has its original finish and the top horn part ofit

 

HANDFORGED EARLY ROUGHING GOUGE. RARE IN-CANNEL GRIND. CLEAN & SHARP. These heavy duty stock-removal gouges, called "U" chisels due to the full half circle profile, are rare. To find one with a ha