A SET "RECORD" CRAMP HEADS 130s (made in england) HAVE BEEN STORED IN MY DAD'S SHED FOR DONKEY'S YEARS (20 yrs minimum) THIS A ONE OF A TWO SETS WE FOUND THE ORIGINAL PACKGING FELL APART THERE IS SOME

 

Found these drill bits in an old tool box. They have numbers on them which I assume are the sizes. Not sure what kind of drill they go to but hope someone can use them.

 

measures 8" long x 2 1/2" wide........the cutting iron, and cap iron, measures 1 7/8" wide and have no rust or pitting...!!!........marked with the Moulson Bros logo.......has a thin piece of wood, pe

 

ASHFLASH LIGHTLY USED LANTERN W/BOX. MODEL NO-L-66. BOX A BIT WORN. FROM 60'S ERA IN REALLY VERY NICE AND WORKING CONDITION. GOOD SHINY CHROME. BATTERY COMPARTMENT L/NEW WITH 0% RUST. LIGHT AND BLINKE

 

cgcollura Store Fully Restored Stanley No. 3 Smooth Plane Type 16 ca. 1933-1941. The bed and frog were re-japanned using my formula. The sole has been lapped flat and highly polished to reduce frictio

 

Up for auction is a 1.75 pound hand forged blacksmiths raising/repousse sheet metal hammer. This hammer was hand forged from 1045 steel using a coal fired forge. It has been properly heat treated and

 

You are bidding on Vintage Original 2N 8N 9N Ford Tractor Tool Kit Open End Wrenches Cleaned, Ready for Show, Display or Use This is an original SET of open end wrenches that was apart of the 7 pc too

 

ON THE BLOCK TONITE ARE TWO STANLEY WOOD PLANES A STANLEY NO .4 SMOOTH BOTTOM AND A STANLEY BAILEY NO.5 WOOD PLANE KNOBS ARE CHIPPED AND/OR CRACKED CONDITION. I AM SELLING THESE TWO PLANES AS DAMAGED

 

A 1907 patent Walworth Parmalee No 1 girth wrench, about a 12” long, the wrench is in good working condition. Made for turning pipe or rod without the marring of serrated jaws, and for turning in ti

 

This is a very nice hand in very good condition, the saw has some Spots on it but overall it's in very good condition. Posted with eBay Mobile