For your consideration is an unmarked come and go tongue and groove plane. The plane is made to center on 1/2" stock, but can be used on 3/8" to 5/8" with an offset joint. Overall length is 9 1/2".The

 

Template ICNPNK2 VTG Japanese Ono Axe,Hatchet Carpentry Tool, heavy strong masakari, Wood NR Description I think that this was made 60 years or more ago.   It is rusted. Please see a picture. Of cour

 

An old Jack Plane in good working condition. There is some rust and discoloration on the unpainted metal parts but the bottom is flat and the blade is sharp. There is some pitting on the blade as I tr

 

Vintage Stanley Yankee No.41Y Push Drill with 9 Bits Nice condition. Thanks for bidding.

 

HUGE Robert Sorby (3) pc Chisel Set. You get a 25mm; 38mm; and 50mm chisel. These are 20" long and weigh over 5lbs. It is in very nice condition. These have been well maintained. Check my other auctio

 

Millers Falls No. 5 manual drill, some rust, some original paint. From the Millers Falls Tool Co. Greenfield Mass. Not locked up, no excessive play, chuck works fine about 13" overall length. Paypal o

 

 

Carving Tools 10 various cuts and uses stone carving chisels. I think these are pneumatic use based on the end styles. I didnt see any maker marks. Fresh local estate find ready for your use or collec

 

18" Miller Falls Hand Plane Made in the USA

 

Here is a Vintage Old B ADDIS & SON SHEFFIELD ENG LONG SCRIBING Carving PARING GOUGE CHISEL (3/8") with BRASS FERRULE & TURNED WOODEN HANDLE MORE PHOTOS BELOW Blade Stamped= B ADDIS & SON