OLD VINTAGE PLUMB BOB MEASURING APX 3" LONG. VINTAGE CONDITION. HEAVY....THREADING WORKS WELL ON TOP CAP. BEST WISHES! NO MARKS ON THIS PLUMB.

 

MINI CAST IRON IH INTERNATIONAL HARVESTER BLACKSMITH TOOL ANVIL ADVERTISING Description A cast iron salesman sample blacksmith anvil tool with "iH" in raised letters on one side. It is 4 inches long a

 

Vintage Milwaukee 24" Metal Tool Box CASE Approx. Measures 24" x 10" x 4" No mechanical damages. Clean inside and outside; Minor scratches, no dents. See pictures. The case was previously used for Mil

 

Wade & Butcher really clean collectible hatchet. well marked nice clean condition see photos. measures approx 12 inches long at handle. head measures 4 3/4 long and approx 2 7/8 across sharp edge.

 

LOT - "J" Group of 16 Assorted key lot. one hollow barrel brass, two small watch winding keys, one heavy Scandinavian. No identifiable manufacturer markings on these keys. Please see pictures and emai

 

Kind of a neat tool that was probably made by a pattern maker for his own use. The nickeled part is a heavy casting that acts as a carrier for the blade mechanism (which is a modified Stanley No. 100

 

Check out the pictures below, for some auctions there may be more than shown above. Marked on the back KEEN KUTTER and 9 for the 9 inch blade length. A little light surface rust to clean off and a sha

 

You are bidding on handled hot slitting hammer. Only light dressing on the business end has been done. Plus - hung with a new handle. Good quality manufactured item. Thank you for bidding.

 

and --> Rare Pair of Russell & Erwin Doggie Doorknobs, NR "> Up for auction is this pair of Russell and Erwin "Doggie" doorknobs. Originally designed and patented (June 7, 1870) by Ludwig Kr

 

Up for bid is an Antique Barn Peg Beam Hand Cranked Auger Drill Wood Handle 1.5" Diameter x 18.5" Long. Back in the day when you built a building there were no nails or they were very expensive, so co