Here are 10 heavy duty blacksmith chisels. They range from 6" to 8" with 1/2in" to 1 1/8"in. wide blades. Some are marked, including, "Enderes", "Blue Grass", "Cornwell", "Davies", "Ajax", and "P&

 

No. 5 Hand Plane marked Gambles Artisan, this plane could use a little attention, rusty in areas but is a good plane. The first block plane is marked Millers Falls no. 56 in decent condition. The othe

 

FOR SALEGreat collectable victorian VR & Crown stamped patent brass padlock with steel hasp & original key In great working condition with an aged patinaWear & marks commensurate with age

 

It's a 2 in.to 3in. Micrometer no.436 made by the L.S. Starrett co.

 

You are bidding on a lot of three, vintage/antique tools. First item is a Pexto cable or tubing holder. Holder measures approximately 10.5" in length. Second item is a sliding t bevel with blade measu

 

THOSE OF YOU WHO HAVE PURCHASED FROM ME BEFORE UNDER "JKRDOLLADOPTION" KNOW THAT I AM SELLING MY LATE HUSBAND'S COLLECTIONS. I SIMPLY DECIDED TO SET UP A COMPLETELY DIFFERENT AUCTION SITE. BUT, PLEASE

 

Description I think this was made about 45 years ago. The total weight : about 450g The width of the blade : about 3.7cm It has rusted. Before using, Please to sharpen blades. Trademark registration

 

VINTAGE FORD SLIP-JOINT PLIERS Length: 6-1/2" approx. Has Ford logo marked on them; also a mark on the inside which I'm not sure what it is . Made of steel; btm. end on one side is for use as a screwd

 

Kelly Works Flint Edge Axe: 4&1/2lb.True Temper. Made in USA. No chips or cracks. 6&1/2" blade from poll to blade edge. 5&1/4" wide blade. Overall length is 790mm. (31") Older original Han

 

NO RESERVE!!!! 6,720 POS. FEEDBACKS , [ NEVER A NEG. ] THE REASON FOR THIS , I BELIEVE IS MY DESCRIPTION BELOW I TRY MY BEST TO TELL IT THE WAY IT IS , [ GOOD OR BAD ] [ NO DECEPTION OR GREED AT ALL,