Description I think this was made about 30 years ago. Unused.But it has a rust. The weight : about 270g The width of the blade : about 1.8cm There is no signature or mark to this. However, it is a goo

 

True Value 3 1/2" Anvil Bench Vise Jaws measure 3 1/2" and opens to around 4 1/2 inches It is used so it does have dirt and minor surface rust ~ Good Working Order ~ See photos, they are part of the d

 

Found these drill bits in an old tool box. They have numbers on them which I assume are the sizes. Not sure what kind of drill they go to but hope someone can use them.

 

Makers name overstamped. To cut a a 1/4" cove. Some bruising to the heel and wedge, otherwise good. Stamped 5/8 and 4/8 on the heel (?)

 

Up for bidding in this listing is a vintage 8 peice set of Craftsman Profesional Lathe Chisils, forged taperd blades, vandium high carbin steel, hardened and temperd, profesional length, chromium plat

 

Here are five awls. They range from 6' to 8'. One is marked, "Millers Falls Co. - Greenfield, Mass. Made in U.S.A. - No. 365" and another is "Craftsman - Made in U.S.A". The other are not marked. One

 

From an estate. Good, usable PROTO slide hammer as shown. +/- 27-1/2" long. Hammer is 2" diameter. Tool makes a great finger pincher also. Straight. Threads are good. Some surface rust and old dust. A

 

mifuqwai Store Japanese My dozuki SAW & how to modify changerable saw Ouch!! What a terrible!!! See the left photo. this is not modified. As you know ,top of the Jap SHIBORIMARUTA CEDER was missed

 

rhendr63435f80 Store Vintage Snap-On Tools 3/8" - 1/4" Drive Adapter. Allow attachment of 1/4" drive socket to 3/8" drive tool. No. TM-1. Made in USA. 1958 date code. Please see photos for cosmetic co

 

Keuffel & Esser CO.  Manufacturers and Importers Drawing Materials Surveying instruments measuring tapes.  General Office & factories Hoboken, NJ branches Chicago, St. Louis, San Fra