A large grouping of keys, some antique, some vintage, some locks for desk drawers/doors, some file cabinet key/lock sets and a sliding glass door key/lock set. Some of the names on the keys are Diebol

 

NICE LOOKING USED CONDITION ~ VINTAGE ANTIQUE SINGLE HUMP UNMARKED MORIN #5 CAST IRON 3" X 1-1/2" CROSSCUT SAW FILER TOOTH SPIDER SETTING GAUGE ~ THESE TYPE TOOLS, WERE ONE OF THE MANY PREFERRED TOOLS

 

This is an extremely clean used once or maybe unused set. All -V- stamped. The ratchet has an M stamped at the clip, and has the little oil nipple. The extensions are 6" 43531, 3" 43539, 1 1/2" 43538

 

You are viewing a L.S. Starrett No. 232 Outside micrometer (.000-.500). This micrometer is in used condition. Scale markings are sharp and clear. Reads zero when fully closed. The head is tight like i

 

Vintage Creative Tools Easydriver Ratcheting Ball Screwdriver USED INCOMPLETE SET(SEE PICTURES) TESTED TO WORK

 

Condition:Good as Vintage.Blade is rusty and nicked. Please check Photos. It has been worn out for age, so it's hard to show original planing performance. Recommend for Japanese vintage carpenters too

 

Antique seal padlock with working key. Brass and steel. About 2-3/4" inches tall and 2" wide The lock does not " pop " open. Just turn the key ninety degrees then pull on the bail. Seven flat keys, ma

 

Up for auction a nice lot of 13 Old, Antique Farm / Tractor / Machine / Auto / Plow Wrenches. Different shapes and sizes. (please view pictures) Most are in very good condition with very little rust o

 

HI AND THANK YOU FOR LOOKING HERE IS A ( ANTIQUE 1940'S TOOLCRAFT CORP. SUPER SANDER METAL PALM SANDER CAR DESIGN, USED, MADE IN USA, IT MEASURES 7" LONG, 2 1/4" WIDE AND 3" HIGH, THE RUBBER IS IN GOO

 

1899 Clark Bros & Co, Milldale Conn Billhead & Request for Quote & Blueprint --- approximately 8” X 6” billhead, 5” X 8” quote request letter from Holmes, Booth & Hayden / Bras