From an estate. Good, usable PROTO slide hammer as shown. +/- 27-1/2" long. Hammer is 2" diameter. Tool makes a great finger pincher also. Straight. Threads are good. Some surface rust and old dust. A

 

Up for bids is a Lot of Snap-on Tools. Included is a Vintage 1/2" Drive Weather Head Socket (Model WH-14) manufactured from 1950-1955. From what I researched, it was used on 7/16" soft copper weather

 

This is a very unusual, but very decorative silversmithing hammer! The hammer is in great condition! The handle is crack and chip free and there is only a slight wiggle at the head. It's unmarked too.

 

Up for auction is a 1.75 pound hand forged blacksmiths raising/repousse sheet metal hammer. This hammer was hand forged from 1045 steel using a coal fired forge. It has been properly heat treated and

 

MONSTROUS 14 INCH Bit Brace - No.921 - SWEETHEART! One Of STANLEY'S FINEST! READY TO GO RIGHT TO WORK!! Fourteen Inch Sweep / Seven Inch Throw. HUGE!! The largest size Stanley offered and one of the b

 

Good used working condition...The 10 CR has some overspray paint on one side that seems to come off with steel wool...Both pair work fine...They are not engraved with any owners names or initials...Th

 

This saw has an etched blade with Harvey W Peace Vulcan saw works Brooklyn New York spring steel warranted patented January 25 1874 re-issued June 10, 1882. The blade has the number 7 stamped in it by

 

Ohio Tool Draw Knife Antique Vintage Tool Woodworking Shows wear and looks to have slightly different handles. Most of the items from this collection are in good condition. Some have been refinished o

 

woodside1 store 1950 VINTAGE HOW TO RUN A LATHE SOUTH BEND LATHE WORKS ILLUSTRATED MANUAL You are bidding on a Great Looking ORIGINAL 1950 Vintage How To Run A Lathe, published by South Bend Lathe Wor

 

Please leave your phone number with your address, item will only be shipped after the phone number received as this is a requirement by the shipping companies 7 x blacksmith Tongs Nippers forge, farri