Up for auction! - - - - - LOT #13-0008 for your consideration and perusal - - - - - - American U.S.A. BRASS PADLOCK - with KEY Junkunc Bros. Imprinted on front of lock (AMERICAN over U.S.A.). Imprinte

 

THIS IS A VINTAGE 7 DRAWER WOODEN MACHINIST TOOL BOX WITH KEY.THERE ISN`T A NAME ON IT BUT I BELIEVE IT COULD BE MADE BY STAR OR NATIONAL TOOL CO.THE TOOL BOX IS IN VERY GOOD CONDITION EXCEPT THE FRON

 

An early L.S. Starrett No. 18A automatic center punch. Has all-steel handles and parts, the internal mechanism automatically strikes a blow when downward pressure is applied. Spring tension, which reg

 

old vintage blacksmith hammer lot 5- hammers2- cross pein hammers 1- rounding hammer1- autobody hammer1- bell system hammer i have shown as much in the pictures as possible if you have any Questions p

 

silverfawkes Store Buck Bros.13/16" Scoop Wood Chisel #16 England ~ Vintage ~10-1/8" Long

 

Stanley # 60 1/2 Low Angle Block Plane, USA Made This is a Stanley # 60 1/2 low angle block plane in good condition. It's just over 6 inches long, not counting the knob, and the cutter is 1 3/8 inches

 

Extremely Rare Nicholson Lee 1767 -1777. Nic Lee – Liverpool’s First Recorded Plane Maker. This plane is one of only 5 known complete planes in existence by this maker. it is a No 10 Round mouldin

 

Large old outside calliper with fine adjustment. Tool measures 19" from tip to base, could be used to measure a up to 24" diameter or more. No brand name / manufacturer that I can see. Mechanically to

 

IRON CITY BRAND BLACKSMITH POST VISE, 5 INCH JAWS, ABOUT 42 INCHES LONG, 70 pounds. Working opening is about 3 inches and depth is about 4 1/2 inches. Jaws close squarely but it is about 1/8 inch off

 

Your bidding on an antique oak machinist tool chest. Has 11 drawers,nichel plated corners and five latches. No brand name,the latches are Eagle Lock Co. and the lock is Yale. Measures 20" tall X 9 1/2