Jack Screws the one on the right is a Simplex and the other is unknown

 

For your consideration at auction: as found at an estate sale - contained in an old cardboard box - an odd lot collection of over 300 pieces of brass grommets, snaps, stops, etc. plus a cast steel 2 p

 

for auction a vintage quick adjust pipe wrench. It is 14'' marked Becklin wrench Ci. Seattle Wash. USA. It is patented March 16 1920. It has been partially cleaned , could use some additional cleaning

 

Bernz No. 1 Blowtorch – This center-feed, quart-size, bottom-fill gasoline blowtorch was manufactured by the Otto Bernz Co. of Newark, New Jersey. The No. 1 differs from the No. 3 Blowtorch only in

 

EXCELSIOR 6 LEVER PUSH LOCK PADLOCK (LOCKED.....NO KEY) Lock is in locked position. and there is no key. Measures approximately 3 1/8" wide (as pictured) x 2 1/4" wide. Has wear including surface mark

 

This is a nice example of a Disston 14" back saw with some of the original paper label still on the handle. The saw is straight, sharp and the handle is near mint condition.

 

2 Old VintageWood Inlay HandledSteel ScrewdriversSmall 1 Stamped GermanyLarge Unmarked Measures About:8 & 1/2" LongSmall About:4 & 5/8" LongStamped:Germany I Am Not An Screwdriver Expert Check

 

This is a Vintage true temper double bit cruiser axe head that is free of wood and in good condition with no visible maker's marks It is 8 1/8" end to end and 4 1/8" across axe bits and the head weigh

 

Rare snap-on air tank!!! Still in working condition, with hanging chain. Have also found out it is a 1931 model.

 

kayleescloset Store Up for auction is this Mini Cast Iron IH Blacksmith International Harvester Anvil. This piece measures 4 inches long and 1 3/4 inches tall. The front has IH in raised letters. Ther