This auction is for 3 old cast Iron Sprockets. The two that are matching have a diameter of 7" not including the teeth on the sprocket. The single has a diameter of 6 1/2" not including the teeth. Ple

 

EXC COND VERONA 3/4" Square Punch Hammer... Here is a very common size punch hammer that has seen very little use and is still in excellent condition... The punch end is still in factory fresh conditi

 

You are bidding on an old VINTAGE SMALL PLUMB BOB in Paper Pouch It measures approx. 1-1/2" long and the attached string measures approx. 16" long. There are no maker marks. It is in good "used" condi

 

Up for your consideration is this neat old Stanley Woodworking Plane Tool. It is made of metal and measures around 7 inches long. Made in the U.S.A. is only other marking. A great old tool to add to y

 

This is a vintage Stanley Scraper No 80M never used in original box. Made in the USA. The bottom of the plane has slight surface pitting from storage which should clean up with some fine emory cloth.

 

VintageStamped:TESTEDToo Many ScratchesCan't Read The Makers MarkRock HammerWeighs About:1 lb 10 ozMeasures About:14 & 7/8" Long6" WideI Am Not A Hammer ExpertCheck Pictures& Judge For Yoursel

 

NICE 5/8" HELLER Punch Hammer... Here is a nice larger size punch hammer that has seen light normal use.. The punch tip is in very good condition and measures 5/8" wide and expands to approx. 1 1/4" a

 

AMT Tap and Die handle in bag with directions. Looks as if never used but I listed it as used not knowing! In other words great condition.

 

Two foot 4 fold rule as shown. Rule folds square, tight, has all 3 pins, edges and markings OK, has an edge scale of 10ths and 100ths of a foot. This is custom scale to this rule, not on 86 1/2s norma

 

Your browser does not support JavaScript. To view this page, enable JavaScript if it is disabled or upgrade your browser. Click Here. Double your traffic. Get Vendio Gallery - Now FREE! VINTAGE OLIVER