VINTAGE 4" WILTON USA NO.4404 SUPER DEEP MECHANIC MACHINIST C-CLAMP. EXCELLENT CONDITION. NO PREVIOUS OWNER MARKS.

 

vintage drill bit holder from the Cleveland Drill bit company. Ready for your collection or work

 

OLD CLAYTON & LAMBERT HAND HELD BLOW TORCH . IT STANDS 10.5 " TALL AND THE BOTTOM BASE IS 5.75" WIDE. I have not used it no guarantee it will work.

 

MysteriousGT store We have a Lot of 5 1950-1975 Snap On VS-Series Angle Head Open End Wrenches up for Grabs! Included in this Lot are the Following Wrenches: (1x Each) VS5224 (3/4") - VS5222 (11/16")

 

Welcome to my Auction. Up for bid today is a Key-Bak key chain holder..made in U.S.A. The round holder has an approximate 2-inch diameter x 5/8-inch thick (including belt loop)...this has a 23-inch ch

 

This crank neck chisel is 1/2" wide. The blade is a hand-forged lamination of "white" steel and wrought iron. Each blade is individually tempered to Rockwell c65ø to ensure a razor sharp edge. The "p

 

WOODEN BLOCK PLANE- HANDMADE WOOD & BRASS TOOL- COLLECTORS ITEM. GOOD CONDITON. WEIGHT 2.5 LBS

 

Used, probably not maintained as well as should have been.............. nonetheless looks to be in condition to be restored

 

2 STANLEY CROW BAR'S , PRY BARS , NAIL PULLERS , CRATE OPENERS , BOTH ARE NO. 1460 ,BOTH ARE AROUND 17 1/2 IN. LONG ,BOTH ARE IN GOOD USED CONDITION.

 

This lock is 2 by 3 inches. The dial is marked Eagle Lock Company USA. There is also a patent date May 22, 1892. The combination is written on the front and on a sticker on the back. Shipping is $5 Po