The pictures show the condition fairly well. Aluminum and 8" long.

 

You are bidding on an old Keen Kutter 320 folding rule. It is wood with brass trim and is in very good condition with moderate use and wear. 12" rule has the Keen Kutter logo and name on the front. Sh

 

THIS VINTAGE SNAP-ON MADE IN U.S.A. GENERATOR CURRENT INDICATOR MODEL MT-110. INDICATOR IS IN GOOD USED CONDITION. UNTESTED BUT LOOKS LIKE IT SHOULD WORK. IT MEASURES APPROX 2 1/2" DIAMETER BY 1" THIC

 

Vintage C.E. BILLINGSMonkey Wrench 7" Drop Forged Has Plumbers name stamped on side - C.R. Seguine I cleaned the face of the wrench to uncover the stamped name in three spots, be sure to see the photo

 

This is an old Heller Bros Cross Pein hammer it weighs in at about 2 pounds. My scale is not that accurate. The faces are used and un messed with, markings are not sharp. In addition to the Heller Bro

 

Unusual Stanley markings, 5 1/2 on frog bottom, O on blade and USMC on chip breaker. Only apology a chip off the side of the heal, as shown in both pictures. The Tote hold down screw is brass too, I h

 

Unlisted Rare Diener “TORRID” No. 033 Blowtorch – This one-quart, bottom-fill, gasoline blowtorch was manufactured by the Geo. W. Diener Mfg. Co. of Chicago, Illinois. The front of the tank is e

 

Vintage Bluegrass octagon head claw hammer. I can barely make out the clover pattern on this hammer and can not see any numbers. I am certain this is a Bluegrass hammer I am not sure which model. This

 

Have questions? Please feel free to ask! Vintage magazine is dated 1905 and it is the Souvenir Edition of the THE HORSE SHOERS JOURNAL. It measures 9 x 12 inches. It has good articles on blacksmithing

 

Up for auction is an, Antique hand Made Old Cast Iron Small Vise Barn Fine In Very good Condition. The approximate measurement is 5 1/2" x 5 1/2" x 2 5/16" depth. More, Bigger Pictures Below No bidder