THIS PLOMB TOOL CO. POCKET FEELER GAUGE TOOL #OOOD IS VERY OLD AND COOL AS WELL AS MY OTHER PLOMB TOOLS. THE "O" IN PLOMB WENT AWAY IN 1930S AND WAS REPLACED BY A "V". IT HAS 5 FEELERS ON EITHER END S

 

This set of Ridgely Graining Combs is in a thin steel case with a gold tone. The case is badly scratched and the label on the back side is partially gone. There are four different width sets: 1 inch;

 

For auction is a set of three antique slate roofing tools probably made in Bangor Pennsylvania but that is a guess. The name stamped on the hammer is AP Koplin and I believe that is the name of the ma

 

A classic in marking gauge design, and rightfully so. The Barrett Patent gauge is a wonderful tool, being very easy to use, accurate, and robust. These tools were produced by several different compani

 

up for bid are three vintage Alfa Romeo wrenchs. numbers on them are 50416 - 99006 - 99004. the number 50416 wrench has been grind on to fit in a tight spot (see pics). name of owner has been put on a

 

Nice old rosewood and brass marking scribe mortise gauge, can't see any maker or other marks. measures 7" long Seller tries to estimate shipping costs as close as possible, however , buyer to pay the

 

This is a wood bottom Liberty Bell Fore plane, 20 inches long with a 2 3/8 inch "J" cutter. The name and number on the front of the plane are long gone and it would take a vivid imagination to even ma

 

This is 1 piece Coopers Axe. 1800's Are from Transylvania. With Handle: 17 inch The steel are 10 x 9 1/2 inch. The Cutting Edge is 9 1/2 inch. The Condition seems to be fair considering the age. Shipp

 

Very good used condition measures 14" overall blade is about 4 1/4" long 1 1/8" deep. Marked Erik Frost Mora Sweden. See photos for condition. Very sharp, only lightly used

 

This is a nice vintage, bevel edged socket chisel marked STANLEY and MADE IN THE USA on the socket. The cutting edge of the blade is 3/8 inches. The steel section of the blade is about 5 inches includ