pbrooksville Store Snap On TQR 250C Torque Wrench with Case Click-Type   Snap-On TQr 250C Torque Wrench, Foot Pound 50-250 In good working condition, has a few scrapes and scratches, comes in origina

 

Up for auction is a Vintage G. I. Mix & Co No.1 EX Wood Chisel 3/4" Wide with No Handle. It is 8 1/2" long and has some wear and some staining and light rust but is in good used condition. There i

 

Vintage Flashlight RAY-O-VAC Baby Bullet Chrome Finish Vintage Flashlight RAY-O-VAC Baby Bullet with Chrome Finish. Used condition and 5 ¼” tall. Please look at pictures for condition and contact m

 

Up for Auction: Two (2) Vintage Jorgensen Wood Working clamps, they are in great condition, they show use but clean no damage or major chips or cracks. Excellent pair for your wood working shop or dis

 

Stanley Tools Description Nice parts or restoration lot of Stanley woodworking tools. Two 45 frames, some parts, each has handle issues, see pictures. Decent 78, near all there? 192 with cutter and ca

 

VintageStamped:TESTEDToo Many ScratchesCan't Read The Makers MarkRock HammerWeighs About:1 lb 10 ozMeasures About:14 & 7/8" Long6" WideI Am Not A Hammer ExpertCheck Pictures& Judge For Yoursel

 

4.5" brass Adams Folger company key. Made when company was in Lemont, Illinois. Yours may differ from picture but is of equal or better quality. 

 

An OLD ~ DRAW SHAVE ~ Logging Tool that is marked I & H SORBY. ~ A company that traces its roots for Generations in SHEFFIELD, England ………………”Indeed, it may be that Robert Sorby is t

 

Disston and Sons Hand Saw 26 inches With Nib circa 1898-1917 I believe this is a No. 16 saw but I can't see Etching to be sure. The etching on this saw is not readable not sure if you would be able to

 

VINTAGE RARE "SITTING CAMEL" SHAPE BRASS LOCK WITH HAND CARVING ON KEY SIZE:- L-9 CM X W-3.5 CM X H-5.5 CM OR L-3.5 INCH X W-1.35 INCH X H- 2.25 INCH (APPROX)MATERIEL:-BRASS SITTING CAMEL SHAPED LOCKH