These were never used, but show a little shelf wear from sitting in the shop for a few years. An interesting way of gluing up solid panels. Per the Lee Valley web site they stop cupping and bowing of

 

Downsizing collection after a winter/Spring of hard picking. The Marshall-Wells has a crack or split on one side?? The Warren has a 32 stamp. The Knot Klipper Warrented is made by Mann Edge Tools, Lew

 

SMALL BENCH VICE FOR JEWELLERS OR SILVERSMITHS ETC MADE WITH HAND RIVETS MEASURES 9 CM LONG. THE JAWS ARE 27mm LONG & 8 mm DEEP THE VICE CLAMPS NICELY BUT THE BENCH ATTACHMENT SCREW IS WORN SO IT

 

Vintage H. Gerstner & Sons, Dayton Ohio, machinist tool chest. Measures 20" L x 11 1/2" H x 8 1/2" W, 8 drawers made of oak lined in green felt that is still in good condition. All 4 corners have

 

This is an infill smoothing plane. It is a casting so not dovetailed. The casting is about 8 1/4 inches long and the blade width is about 2 inches. Stuffing appears to be Walnut. Blade is marked Buck

 

wood box is 5 /2" long-3" wide with compass and related tools-note brass not rusted but ends need cleaning-buyer pays $5.00 shipping USA-always ask questions-thank you and God bless

 

3 - VINTAGE ANTIQUE COPPER & BRASS TIP BLOW TORCH SOLDERING IRON TOOL : Up for auction are these 3 VINTAGE ANTIQUE wood handle COPPER TIP BLOW TORCH SOLDERING IRON TOOLS. THE LARGER ONE HAS A COPP

 

Up for auction is the great Vintage/Antique Cast Iron Pulley. This pulley is in great shape except for dirt, some oil. The pulley is 13 inches in height by 5 3/4 inches at its widest point. This pulle

 

STUNNING RARE TOOL HAMMER CHISEL NAIL PULLER MARKED FERGUSONS QUALITY TOOL PLEASE NOTE I AM ONE OF THE FEW SELLERS ON EBAY THAT REFUNDS ANY EXCESSIVE POSTAGE PAID.IF I HAVE CHARGED YOU £15 FOR POSTAG

 

Vintage Cast Iron Lead Melting Pot About 6 1/2" in Diameter. Any questions just ask Thanks for looking