If you like vintage and antique tools, then Check out my other items! Nice vintage mallet.Measures approximately 11" long. Head is approximately 5" long x 2 1/2" in diameter. The entire mallet weights

 

Old English saw, sort of a stubby little fellow. A Top-Shelf English maker of superb quality is evident. This one would be an asset to any bench or shop. Dovetail, Mitre, Cut-Off, general use... Nice

 

floats FLANGE MOLDING PLANE - Round Profile (Part of a set of two) INRO MEN TORI KANNA MALE Dimensions: Length 24cm Width 6.5cm Blade 4.8cm Weight 740G PAYMENT PAYPAL (Please pay within 5 days of winn

 

For your consideration is a very nice, clean, accurate Ohaus 2610 Triple Beam Balance. Doesn't get any better. I will combine shipping to $ave you $$. For your consideration is a very nice, clean, acc

 

2 Nice Small Collectible --4 oz--Ball Peen Hammers plus --10 1/2" --& --9 1/4" Handles. One stamped---Maydole-- and the other--Vaughn. Very little dings, etc. Have--3 1/2" heads---with --3/4"--ham

 

Carving Tools 10 various cuts and uses stone carving chisels. I think these are pneumatic use based on the end styles. I didnt see any maker marks. Fresh local estate find ready for your use or collec

 

Up for auction is a good solid 60" piece of iron hay trolley track. There is no heavy rust or thin spots. It comes with 2 good hangers. It is 2" wide and 1 5/16" tall. This track fits Louden, Ney, Por

 

Japanese vintage axe head. The axe is made from high carbon steel and laminated blade. The blade has been sharpened with #800 water stone. The cutting edge is 114mm. The width is 130mm. The weight is

 

This auction is for 1) Billings & Spencer # 83 1 1/2" Hand Vise in essentially NOS condition (You'll See! :). 1 1/2" Jaw width & 1" max opening.. Made in Hartford CT between 1911 and 1926 .Spr

 

Estwing Pointed Tip Pick 11" Hammer with Cushioned Handle - Made USA There is tarnish, rust on the steel. Paint marks on the handle.Cushioned handle is intact. Decals are mostly complete.Check out my