A softcover reprint put out by the Smithsonian in 1966. EXC cond. All items guaranteed as described. Shipping/handling $4.00 to US (internationally actual shipping plus $3 handling). Check Out My Othe

 

Starting with the chisel closest to the ruler. 1) a dovetailed socket stamped "T.H. Witherby". I assume it was made to receive different cutting blades. 2) 3/4" wide gouge stamped "EVERKEEN", 6 1/4" b

 

Up for bid is this vintage Brakefix Brake Relining Kit by H&R Products Co. Cleveland Ohio. I believe this kit is complete less parts and instruction sheet. The anvil was ground to make it a little

 

ACORN BRASS MANUF'G CO. CHICAGO "CHAMPION" ONE PINT BLOWTORCH VERY RARE SEE Vintage Blowtorches p11 (THIS IS THE ACTUAL TORCH PICTURED IN THE CLOSEUP OF THE PUMP KNOB IN BOOK)THIS MAKER IS VERY HARD T

 

This is a vintage ESCO grub hoe head in good sound condition with normal wear for age. It is 10 1/8" end to end and 5 3/4" at bit. It weighs 3 lbs 6.9 ozs and is free of handle. Please refer to close

 

Plumb Axe 4&1/2lb. A bit rough with the poll cracked and has been welded. 6&3/4" blade from poll to blade edge. 5" wide blade Overall length is 800mm. Older original Handle which is in fair/go

 

Antique Ball Peen Hammer 1 1/4 lb My Dad's hammer from back in 1930s or 40s

 

Lot of (45) Tools - Pliers, Snips, Tape Measures, Nippers, Glass Cutters, Wire Strippers, Wire Cutters, Tile Crimpers, Needle Nose, Tubing Cutters, Saw & More Some of the Makers Include: Crescent,

 

20 MISC Punches, Chisels & Drifts... Here is a nice selection to have around any type of shop, these are all good quality made from tool steel.. Some of these have seen more use than the others an

 

Vintage used condition I'm not sure if it is the original handle Poorly sharpened Blades edge has some dings Has some rust, scratches, wear, and dings (as seen in pictures) Back end of the hatchet is