I PURCHASED THIS VISE AT AN ESTATE SALE. IT IS IN GREAT USED VINTAGE CONDITION. THE ONLY MARKINGS IT HAS IS " MADE IN USA" AND "2433". COULD IT BE AN EARLY WILTON OR COLUMBIAN? I AM LEAVING IT IN ITS

 

This is a vintage collins single bit axe head that is free of wood and in good condition with clear markings. The head is 7 3/4" end to end and is 4 7/8" across axe bits. The axe head weighs 4 lbs 6 o

 

UP FOR BID IS THIS VINTAGE WARDS MASTER QUALITY(MADE BY STANLEY)..No.65 LOW ANGLE BLOCK PLANE WITH ADJUSTABLE THROATJUST LIKE THE STANLEY #65 WITHOUT THE MARKINGS ON THE CAP OR THE REAR KNOBKNUCKLE JO

 

Vintage Stanley Bailey Plane No 5. Needs clean, as found in this condition, untouched.

 

GREAT SHAPE AND FULLY WORKING ALTHO A DEGREE IN MECH ENGINEERING MAY BE NEEDED TO FIGURE IT OUT........POSTAGE IS $14 TO THE LOWER 48...WORLDWIDE AT COST...........................I DO TAKE TRADE INS.

 

for auction a vintage quick adjust pipe wrench. It is 14'' marked Becklin wrench Ci. Seattle Wash. USA. It is patented March 16 1920. It has been partially cleaned , could use some additional cleaning

 

Vintage Bench Top Mount Vise. 7 " long , Jaws 2 1/2 " wide. Jaws open to a maximum of 2 1/2 ". Four screw holes will allow you to mount the vise anywhere on the work surface. Although this particular

 

Good + Condition. The thoughtful restorer could do a lot worse than this. Surface rust. Almost all parts except bulbous hand part that retains blade, and, the blade itself. All the parts except the kn

 

Vintage E.A. BERG Bevelled Edged Chisel - 1½"Blade measures 5¾" from cutting edge to mouth of socket.Has a few small dings around mouth of socket - pls. see detailed photos - which obviously won't a

 

Here is a very nice example of a 12" Back Saw manufactured circa 1917-1927 by Henry Disston & Sons in Philadelphia. This Saw remains in very good useable condition. The 12" blade has only light ag