Up for Auction are these 2 used Blacksmith Hammers. The top one in the first picture is an IRON CITY WARRENTEED 1/2" hole hammer. The other one is a A.B. CO. 3 LB. Cross Pein Hammer. Both handles are

 

HERE WE HAVE A MYSTERY LANTERN THAT APPEARS TO NEVER HAVE BEEN USED BUT I SPENT ALL THE PATIENCE I HAD TRYING TO FIGURE OUT HOW THE SPOT LIGHT WORKS! I DON'T SEE ANYTHING MISSING AND IT'S ALL PERFECT

 

In very good, little-used condition. Slight bruising to wedge only.

 

UP FOR AUCTION IS A VINTAGE DISSTON 10" BACK SAW. THE BLADE HAS A SLIGHT WAVE IN THE MIDDLE AND THE HANDLE HAS A TIGHT CRACK NEAR THE NUT. 1896-1917 MEDALLION 11 TPI. ONLY PLATE STAMP IS VISIBLE.PLEAS

 

This is a front knob and fixing screw for a stanley defience 14" inch jack plane, it has a bit of the finish marred as you can see in the pics.

 

Hi there, You are bidding on a Vintage set of Stanley Yankee Screwdrivers, Millers Falls Drill Jig Saw, And An Old Lufkin Tape Measure. These tools are in decent used condition with paint loss, nicks,

 

Vintage Starrett No. 12 Combination Square 2 PARTS only ~ Protractor & 90º ~ Used 2 pieces ~ ruler is not included. Flat surface of protractor is only ⅜" wide x 7" long. 90º is ¾" wide. Level

 

2 old leather cutting tools makers name on both is Karl Leister one is older than the other. the brass ferrule on one of them is a bit crushed inward. see pictured.

 

VINTAGE PEXTO NO. 7 MADE IN U.S.A. LAID BLADE FORGED STEEL FOR CUTTING STAINLESS STEEL. NICE CONDITION FOR AGE. SEE PICTURES. MEASURES 14 1/2" LONG. OPENS AND CLOSES NICELY. I DID NOT CLEAN IT AND IT

 

This Jennings wood chisel is in very nice condition. It is approx. 1/4" and approx. 10" in length. Has a nice wood handle. It is marked C.E.Jennings Made In USA on the blade.