Antique Millers Falls Hand Drill This is a vintage Millers Falls egg beater crank hand drill. It dates back the early 1900's. This Is a No.5 Hand Drill Manufactured by the Millers Falls Tool Company o

 

This is an older, 6" Stanley 60 1/2 block plane.It is complete. The metal has been corroded in several areas due to use and weather, but does not affect the performance of this little plane.This old b

 

This pulley is 6 3/4 lb. in weight. The wheel is 9 1/4" in dia.. The frame is 11 1/2" in length. The hook is 3" long. There is place in the frame where you can take the hook. out and replace it. Pulle

 

TRUE TEMPER TOMAHAWK NO.TH SINGLE BIT AXE HATACHET NICE! NICE LOKING VINTAGE TRUE TEMPER TOMAHAWK AXE HATCHET, 11'' HICKORY HANDLE, HEAD IS 5 1/2'' X 3 1/4'', HANDLE SOLID MARKINGS TRUE TEMPER TOMAHAW

 

This auction is for an old vintage brass folding key that I believe was used in pocket doors. It is approx. 2" long. When the top folds down it is approx. 1 3/8" long. It is in very very nice conditio

 

NICE VINTAGE BALL PEEN HAMMER MARKED ON THE HEAD PASCHALL # 35 1306 PAT. BB MADE IN USA 9.1 OZ. MEASURES 11 1/4'' LONG. HAMMER HEAD MEASURES 3'' LONG, HAMMER HEAD FLAT END MEASURES 7/8'' WIDE. GOOD VI

 

SELLING A NEW SMALL TABLE VISE- MACHINIST - WOODWORKING- NEVER USED . COMES WITH EVERYTHING AS SEEN IN THE PICTURES. IT COMES WITH EVERYTHING SHOWN IN PICTURES . PLEASE SEE ALL PICTURES. Please examin

 

Vintage Starrett No. 12 Combination Square 2 PARTS only ~ Protractor & 90º ~ Used 2 pieces ~ ruler is not included. Flat surface of protractor is only ⅜" wide x 7" long. 90º is ¾" wide. Level

 

KD Tools - KD 2031 - Chain Pipe Cutter - This early model (without plastic coated handles) of the cutter made today both share the same model number KD 2031 - 3" pipe cutting ability - Often used exha

 

This auction is for 3 old cast Iron Sprockets. The two that are matching have a diameter of 7" not including the teeth on the sprocket. The single has a diameter of 6 1/2" not including the teeth. Ple