Up for auction is this very heavy axe head. The head measures 7 1/4" in length and has a 5 " cutting edge. I can tell its been reconditioned from the re-grinding on its poll.(back end of head) This he

 

H. Gerstner & Sons Machinest or Journeymans Wooden(Oak) Tool Chest Box Marked on the inside: Built by 79876543 H. Gerstner & Sons Dayton Ohio V 482 (in pencil) See picture #9 16" X 20" and is

 

this jig has minor surface rust that can be cleaned off with light rubing with 440 grit paper then keeping them waxed. comes with the 5117 1/2 " Half-blind DovetailTemplate

 

As you can see, a very different way of solving the problem of securing a kitbag mouth! key is unfortunately missing, but it looks to be a simple one that could be improvised! Most of original painted

 

This is a very interesting herkules multitool from Germany. it's two pieces of metal together, can be separated into two separate tools. in good condition. please message me with any questions. note:

 

no markings, in great shape. no warping or writing,used by a jeweler watch reapair craftsman, not abused.

 

There is a Barron multi purpose wood planer, three small hammers, a 1-32 KK punch, a Stanley Yankee #4595 screwdriver, a cast iron level, no maker's mark, a 6 inch sliding T bevel, two sandcasting too

 

(2) NEW Lufkin "Red End" Flat Read Wood Folding Engineer's Rule The white one is 8' the yellow one it 6' Posted with eBay Mobile

 

RARE MINT "ATHA" Half Round Hot Cut Hardy.. Here is a chance that most small anvils owners dont get very often ... This is a MINT N.O.S. ATHA half round Hot Cut with a factory small 1/2" hardy shaft..

 

VINTAGE A.H. REID CO. HAND DRILL PAT 1882. HANDLE IS NOT CRACKED, VERY OLD TOOL. THIS WAS MY GREAT GRAN FATHERS TOOLS, HE WAS A CASKET MAKER. I WILL BE LISTING A LOT OF THESES TOOL, SO CHECK BACK TO S