L.S. Starrett Company Hand Vise with Clamp #86A. New in box! Marked on the box as EDP 50404. High quality precision tooling! Priced to sell!! Has been in storage - mint condition. Please email me if y

 

Vintage "KING DICK" 1/2 inch drive ratchet handle. Length is 10 1/2 inches. Still works o.k. and ratchets o.k.

 

Shipping Policy: I combine shipping on all purchases. I am also not responsible if your item gets lost or stolen in the mail. You might want to consider shipping confirmation and/or insurance. I will

 

Here is an Eclipse adjustable wrench that is made in Sweden. This wrench is great for a tool kit in a car, motorcycle or boat. Small enough to fit in a pocket ot backpack, 8" long. This has never been

 

8x Vintage stone mason Blacksmith Hand forged hard iron tools hardy chisels , punches working, carving circa different styles and sizes complete set I accept cheque, Paypal, bank transfers Postage Ite

 

General Hardwear Mfg. Co. N.Y. Multi gauge. No. 16, 1937. Rule, protractor, square, centre finder, circle divider, drill point gauge etc.

 

Snap On vintage MT380 scanner for 1980-1/2,1981,82,83,84, and 1985 GM with computer command control (3c), Electronic fuel injection (efi) or Port fuel injection (pfi) looks like it was used once, acqu

 

BIG 6 Lb WARWOOD Chipping Hammer... Here is a nice large size cutting/chipping hammer still in very good condition.. The cutting edge is factory fresh and sharp, measures 2 1/2" .. The hammer face sho

 

Good older Starrett #362 protractor with nickel plating. It has some wear and some loss of plating, but it is a handy usable tool. It measures 6 1/8 by 10 3/8 inches. It will sell without reserve to t

 

Nice Vintage Stanley Yankee Number 41Y Bell System Wood Working Push Drill with the Bits/Drills A Stanley Yankee push drill marked Bell System NO 41Y. This tool is approximately 9 ¾” long. This ite