This auction is a Lot 14 various size Vintage AUGER spoon bits, reamers, and drill Bits. They are stamped Liviingston, Thomas,& Snell & Bros. The bits have some dirt and rust on them. If you w

 

Vintage Dekalb Agricultural Assoc. Inc. Dekalb, Ill. Made by Jiffy Way Patient Number 2205917. Nice detail.5 1/2" to top of egg holder 8 1/2" x 2 1/2". on bottom.

 

I have looked at hundred of Millers Falls hand drills and cannot identify this one. It clearly says "Millers Falls Co. Millers Falls Mass." on the piece next to the handle, but it has not a shred of r

 

THIS IS A VINTAGE ODD LOOKING HAMMER FOR PEEING METAL.GOOD FOR BLACKSMITING. THIS HAMMER IS MARKED DIXON-5. IT IS 7" LONG. ON THE ONE END ITS 1 1/2 TO 1 1/4 OVAL AND 1 1/4 TO 1 1/8 OVAL ON THE OTHER S

 

YOU ARE BIDDING ON A 3 PIECE SET OF SNAP ON FLARE NUT WRENCHS 1INCH RX32 ,1 1/4 RX40 , AND 1 3/8 RX44 MADE IN USA LIFETIME WARRENTY DONT MISS THIS DEAL THANK U FOR YOUR BIDS

 

For bid is the Old Millers Falls 430 Hand Drill pictured. It works fine, turning and ratcheting left & right. The tool does have some wear from use and storage. Pat. Applied for. U.S.A. MADE. PATE

 

This auction is for a 1985 MAC 3/8" drive 24 Karat Gold Plated RatchetThe Ratchet has NEVER been used, always stored in the original box/case.The case and inner foam has wear on it since it is 27 year

 

Selling a vintage or antique socket and drive set, this set includes 24 Pieces. This has 20 heads all in different sizes, some of the heads have teeth down inside and others do not, These range in siz

 

Vintage Pulley U-W 3PB. A really cool looking double pulley. Wood measurements - Width across the front measures 2.75 inches. Width on the side 2.50 inches. Height 3.50. Wood looks to be oak. Pully we

 

Mrsdeadhorse Store Here we have a real find and that would be a Large [ measures just over 1 ft overall] SCREW PLATE that was found in a set of old antique Gunsmith tools that I bought some years ago.