This beech plane measures 10-1/4x2-7/8 inches. There is no makers mark. The unmarked cutter is 2-3/8 in wide. The wedge is Filipine mahogany (Luan) so an obvious replacement. It has a few worm holes a

 

Greetings and welcome. You are bidding today on a vintage machinist level. Manufactured in New Orleans right here in the USA it was made by Hall Level and is marked No 50. I find no indicator as to wh

 

Has a dual etch on the blade. THe standard THE SIMONDS SAW WORKS FITCHBURG MASS CHICAGO ILL. U.S.A. and MADE EXPRESSLY FOR DAVIS THE HARDWARE MAN BOSTON MASS, the medallion is marked THE SIMONDS SAW M

 

Miniature Workbench Description: 4-1/4" x 3-1/4" x 1-1/2" handcrafted - artist signed - miniature workbench - with moving woodworker. Check photos in super size view to verify condition. Estimated car

 

A pre-owned vintage wrench tool lot, includes snap-on mac and other brands, of note is an interesting bridgeport X wrench set. All have seen previous useage, include scratches scuffs id marks corrosio

 

You are bidding on two flashlights. One Ray-O-Vac and the other a Sportsman. Batteries not included. Slightly used and sold ASIS.

 

Four vintage Hand carving Chisels . With handle, WARD W ... P stamped on blade . Measures approx 8" inches top of handle to the chisel tip . Three (3), chisels minus handles . . . One stamped B. ADDIS

 

No reserve on an antique D.R. Barton Wood Molding Plane in very good condition. Skewed iron is 5/8" wide. Both irons are in good condition. Depth stop has wooden thumb screw. Front is stamped with "D.

 

Vintage 1 ¼ oz. (35g.) silversmith’s / jewellers hammer in good condition. A fine light weight tool with a clean rust free head with a ½” (12mm) diameter head with a slight convex face and taper

 

VINTAGE CRAFTSMAN AUGER BITS ASSORTED LOT OF 15 PIECES. MADE IN USA MADE IN USA. MOST OF THE BITS WERE MADE BY CRAFTSMAN ALL BITS IN GOOD CONDITION. CRAFTSMAN 16/16''12/16'',11/16,10/16'',CRAFTSMAN NO