This crank neck chisel is 1/2" wide. The blade is a hand-forged lamination of "white" steel and wrought iron. Each blade is individually tempered to Rockwell c65ø to ensure a razor sharp edge. The "p

 

Please please refer to all pictures for every detail on this nice chisel thank you and please feel free to visit the store

 

Stanley Overall Weight: 1lb, 6.3oz Overall Length: 13" Head Length: 4 1/2" Head weight 16oz Face Width: 1" Handle is original and tight in head

 

Has a dual etch on the blade. THe standard THE SIMONDS SAW WORKS FITCHBURG MASS CHICAGO ILL. U.S.A. and MADE EXPRESSLY FOR DAVIS THE HARDWARE MAN BOSTON MASS, the medallion is marked THE SIMONDS SAW M

 

A selection of vintage hardware that I found today while sorting through the flotsam at the back of the workshop. Dowels Screws, 1000's of Wing Nuts, nails, Masonry Anchors and even a fair dinkum Vint

 

Carpenter Saws Two older Simonds saw tool pocket guides. Probably 1920's era, but I did not see any dates. One book has a textured cover, both are about the same on the inside. Many picutres and descr

 

1 3/4IN BEVELED CHISEL UNREADABLE NAME SOME OF THE NAME IS READABLE SEE PICS THERE ARE SOME KNICKS AND PITTING

 

Starting with the chisel closest to the ruler. 1) a dovetailed socket stamped "T.H. Witherby". I assume it was made to receive different cutting blades. 2) 3/4" wide gouge stamped "EVERKEEN", 6 1/4" b

 

Old English saw, sort of a stubby little fellow. A Top-Shelf English maker of superb quality is evident. This one would be an asset to any bench or shop. Dovetail, Mitre, Cut-Off, general use... Nice

 

A great collectable MASSEY FERGUSON EN18 Tractor spanner with the usual markings as shown in pics. In good used condition.