*** SNAP-ON #HEX REHTHREADER TAPS AND DIES *** This auction is for a used Snap-on TRT60F hex rethreader taps. Also included is the TRF7B hex rethreader dies. NOT complete. Some wear. All items are as

 

NICE OLD IRON BLACKSMITHS BENCH ANVIL~ 6 3/8 " LONG X 1 3/4 " WIDE X 3" TALL ~ GREAT LITTLE HORN &NICE SQUARE EDGES~ ABOUT 5 LBs. ~ I SEE NO MARKINGS TO BE SURE OF ~ CONDITION IS EXCELLENT ~ ANY ?

 

This is a NO Reserve Auction SAVE $$$$ & TIME USE "BUY IT NOW" Vintage Timing Light KAL-EQUIP CO., GTSEGO, MICH Model L-5.UNTESTED: As shown in photo. NO observed defects..Please email me before b

 

Relisted due to non payer A nice old cast brass lever cap and knurled screw stamped EP 2 1/8 The lever cap is slightly proud of two and one eighths inches wide 55mm. It weighs 215g unpacked. Please ex

 

Vintage Millers Falls 3" Belt Sander Model 830 6amp- this is in very good working condition left under a awning & sanding belt corroded but machine is still in great working condition looks like i

 

Mismatch of good tools. Total of 17 pieces snap on consist of 6 pieces; 1/4" Snap on Rachet MIDGET M-70L (handle repaired excellent) 3/8" Rachet F730 (missing reverse lever) 1/4" speeder handle 1/4"x

 

Vintage Craftsman Bench Vise 3 5/8" Wide Jaws - 4" to 4 1/8" opening capacity- 180 degree Swivel - works great - holds strong Works Great - Holds very strong- Clean - vise has been disassembled, clean

 

In quite good shape a little rust to remove or leave as patina Posted with eBay Mobile

 

Up for bid is a vintage pair of Vacuum Grip era Snap-On Tools "Midget" slip joint ignition pliers (No. 105). The pliers came from the estate of a former Snap-On Tools employee, who worked at the compa

 

High Power CREE LED 800Lm Mini Flashlight 3 mode Water-Resistant, you can use it in a rainy day Fast shipping to USA (with tracking number), takes 7-15 working days Very Mini and very bright, Easy to