*** NEW GREENFIELD 3 PIECE TAP AND DIE SET ~ LOT #1 *** This auction is for a brand new 3 piece tap and die set. EDP 11551 7305 10-24NC HS Set All items are as pictured. All items may need to be clean

 

Here is a VINTAGE LEVEL that I believe is made of BAKELITE. It is 4 3/8" LONG and in GOOD CONDITION with some wear but no damage. It appears to be accurate and was made by the GARRARD COMPANY in ENGLA

 

For sale is a vintage Will-Burt Co. Versa Vise. The design allows vise to be mounted vertically or horizontally on the base mounting shaft and then it locks into position when the jaws are tightened.

 

This is a vintage collins single bit axe head that is free of wood and in good condition with clear markings. The head is 7 3/4" end to end and is 4 7/8" across axe bits. The axe head weighs 4 lbs 6 o

 

True Value 3 1/2" Anvil Bench Vise Jaws measure 3 1/2" and opens to around 4 1/2 inches It is used so it does have dirt and minor surface rust ~ Good Working Order ~ See photos, they are part of the d

 

LOT - "J" Group of 16 Assorted key lot. one hollow barrel brass, two small watch winding keys, one heavy Scandinavian. No identifiable manufacturer markings on these keys. Please see pictures and emai

 

I am selling some of my father's collections. I have a 30 inch vintage Keen Kutter saw. Good luck!

 

This is a lot of misc hammer heads that are all sound and free of wood. The claw Hammer is marked Plumb and the striking sledge is marked mexico so that would be a new collins hammer. The old RR spike

 

Very nice clean mini ball bearing chuck. 0 - 1.5. Made in Germany. Buyer pays actual shipping. Paypal accepted.

 

duffys-digs Store Steel State Eight Lever Padlock with Key