MADE IN ENGLAND -- 26 - POINT - DOVE TAIL SAW -- ITS - 9 - 5/8 - INCHES LONG OVERALL -- THE BLADE IS - 5 - 1/16 - LONG -- 5 / 8 - OF AN INCH UNDER THE BACK -- HAS A BRASS BACK & COPPER FERRULE --

 

HI AND THANK YOU FOR LOOKING HERE IS A ( ANTIQUE 1940'S TOOLCRAFT CORP. SUPER SANDER METAL PALM SANDER CAR DESIGN, USED, MADE IN USA, IT MEASURES 7" LONG, 2 1/4" WIDE AND 3" HIGH, THE RUBBER IS IN GOO

 

Collection of (8) T-Handle Gimlet Screw Starters Overall lengths range from 3 7/8" to 6". All have wear including surface rust that has been buffed, tarnish, scratches, nics and overall usage. Please

 

Here is a very rare Spanish Colonial hand forged iron cactus picker. Some small cactus were used for food. This was the tool used for harvesting them. From about 1750-1800. Note the offset in the shaf

 

This key is in good condition. On the back on the wooden thing connected to the key, it says "206". Not sure if that matters.

 

11x4.25" This antique scale is cast iron with a brass face. It is in very good condition for its age, and is complete with hanging ring and hook. The scale will weigh up to 30 lb capacity , and the me

 

NICE VINTAGE BALL PEEN HAMMER MARKED ON THE HEAD PASCHALL # 35 1306 PAT. BB MADE IN USA 9.1 OZ. MEASURES 11 1/4'' LONG. HAMMER HEAD MEASURES 3'' LONG, HAMMER HEAD FLAT END MEASURES 7/8'' WIDE. GOOD VI

 

cast steel.

 

In very good, little-used condition.

 

Up for auction is this machinist lot of used carbide tool bits in assorted sizes. These tool bits have been used but are in good, working condition. Some may need sharpening. Please ask any questions