Atlas Copco, Jiffy, Dotco and assorted Aricraft tools. Including Bushings and step up reamers. Make me an offer. Everything from 500 Rpm 1/2 inch Drill to 3300 Palm motors. Also including angle motors

 

Atha Stanley Flatter Hammer Blacksmith Anvil Forge Tool Roughly 2- 3/4" to 2-7/8" Square Flatter Hammer. The hammer's face does have marks from use. The edges do have marks. Head Overall length measur

 

Another nice vintage Stanley woodworking carpenters tool clapboard or siding tool in good clean condition just like the other one that I have listed.

 

This is a wood bottom Liberty Bell Fore plane, 20 inches long with a 2 3/8 inch "J" cutter. The name and number on the front of the plane are long gone and it would take a vivid imagination to even ma

 

HANDFORGED EARLY ROUGHING GOUGE. RARE IN-CANNEL GRIND. CLEAN & SHARP. These heavy duty stock-removal gouges, called "U" chisels due to the full half circle profile, are rare. To find one with a ha

 

Don't really know much about these but appears in good cond. Blade is sharp and not chewed up. Metal surface is flat and smooth. Tool appears almost new.On Oct-12-12 at 05:41:14 PDT, seller added the

 

this is for a Vintage Yankee 131A Spiral Ratcheting Screwdriver and Rare Chuck Bit.....Pat. Dec. 11, 1923........measures 16 3/4" closed and 25" open (without bit)....ratchets in both directions just

 

Here is a Vintage Carpenters WOODEN RARE Side Rebate MOULDING PLANE Blade/Iron By THOMAS IBBOTSON ALL ORIGINAL-I have not made any attempt to clean this up Condition=Plane is in vintage Used Like new

 

Vintage Snap-on 3/8" drive 6" extension SX-6 in good conditionPlease view photo and email with any questions

 

Up for auction is a Stanley 112. There is rust and pitting. The blade is missing.The knob and handle are in very good condition made of walnut with some finish missing.There is approx. 60- 70% of the