THIS MACHINIST LEVEL IS USED BUT IN GOOD CONDITION.THIS LEVEL WAS MADE IN USA IN NEW BRITAIN CONN. THERE ARE A FEW SURFACE RUST SPOTS ON IT.IT NEEDS A GOOD CLEANING AND THERE IS NO NICKS ON IT.

 

Gransfors Bruks GBA Double Bit Axe 11", 3-1/2lbMade in Sweden click picture to enlarge click picture to enlarge click picture to enlarge click picture to enlarge click picture to enlarge click picture

 

Up for bid we have a Vintage Sargent Combination Plane #1080 with 22 Cutters. This plane with cutters is fresh out of a storage locker, I'm offering it as I found it. I would rate it in good to very g

 

Quite nice for being VERY old. Shows its age some but I would say still very useable. By the one lever it says Pat'd 10- 12- 97. One the back lever it says STANLEY. The bottom is 6 1/4" x 1 7/8" x 2 1

 

15.00 This is a genuine Victorinox Swiss Army Model Climber Knife. It has the green Cellidor handles with the image of a fish and the L.L.BEAN logo on one side and the Victorinox shield on the opposit

 

New and unused in box with wrapping paper. Rust free, perfect condition! Delivery to USA lower 48 statses only. No returns.

 

Ulmia Ott #60 Buck Saw with Five Blades Made in Germany Very nice Ulmia Ott buck or bow saw. This saw has very little if any use. Ulmia Ott was known for high quality workmanship. Complete and free of

 

A Snap-On --CJ92 Battery Terminal Puller in Good Condition. Great for pulling battery terminals without damaging them and also can be used for other purposes.

 

this jig has minor surface rust that can be cleaned off with light rubing with 440 grit paper then keeping them waxed. comes with the 5117 1/2 " Half-blind DovetailTemplate

 

Vintage Double-Bit Axe Head marked M 3&1/2 Found in a shed at a farm estate this vintage double-bit axe head . Only markings on it are M 3&1/2. My scales weigh it at 4 lbs. so I'm not sure if