Vgc

 

STARRETT 827B EDGE FINDER IN GOOD WORKING CONDITION SHOWING NORMAL USE. IT HAS OWNER INITIALS ON POINTED END TIP. IN AS FOUND CONDITION. COMES AS SHOWN WITH PLASTIC CASE AND BOX.

 

Up for bids I have these great, steel antique skeleton or barrell keys from the mid to later 19th century. 2 and 1/8th to 2 and 3/8ths inches long. The keys are great and beautiful and have VERY EXOTI

 

On offer is a bundle of 6 short shaft vintage keys - handy for the furniture restorer. All appear different range from 30-48mm long. Came from an estate where much of the material was from the 1950's

 

Up for auction is a 12” adjustable wrench in the original box, in mint condition, made by Diamond Calk Horseshoe Co. of Duluth, Minn. One corner of the box top is split and the edges are a little fr

 

This beech plane measures 10-1/4x2-7/8 inches. There is no makers mark. The unmarked cutter is 2-3/8 in wide. The wedge is Filipine mahogany (Luan) so an obvious replacement. It has a few worm holes a

 

This is a 14 In. Bell System-B Ratcheting Bit Brace This bit brace is in very good condition. It is 14 inches long with a 10 inch sweep. Has minor scratches from normal use. Has no rust or pitting. Al

 

VINTAGE "JIFFY-WAY" EGG SCALE OWATONNA, MINN. WORKS SCALE has rust. 0 0 1 56 323 Lobo Graphics 2 1 378 14.0 Normal 0 false false false EN-US JA X-NONE I will be selling several Items from my father in

 

THIS IS A VINTAGE BOXED STANLEY 13-050 COMBINATION WOODWORKING PLANE,IT IS COMPLETE PHOTOS DONT SHOW THE BARS BUT THEY ARE THERE,IT HAS NOT BEEN USED AND IN QUITE GOOD CONDTION MINOR WEAR FROM BEING S

 

4 new hand forged blacksmith tongs. Tongs are forged from A-36 steel and made to fit 1/8", 1/4" and 3/8" flat or square stock respectively (flat jaw tongs) and the bolt tong is sized for 1/2" square o