Stanley No. 81 Scraper Plane Rosewood base. Cutter marked with V shaped font logo: " STANLEY NEW BRITAIN CONN USA" A very nice fully functioning plane for use in the shop or as a collectors piece. Shi

 

This is a vintage Plumb 3 2 double bit axe head that is free of wood and in excellent condition with excellent markings also marked FS for forest service The head is 9 7/8" end to end and 4 1/2" acros

 

17" long in good condition. still has the inner cardboard liner

 

Atha Stanley Flatter Hammer Blacksmith Anvil Forge Tool Roughly 2- 3/4" to 2-7/8" Square Flatter Hammer. The hammer's face does have marks from use. The edges do have marks. Head Overall length measur

 

kirahere Store Snap-On Socket Lot 1/4" drive - 6 point - SAE - Deep Well Socket Set STM 6 through STM-14 - 3/16" through 7/16"Excellent Condition - Owners Initials are Present on all the SocketsPlease

 

50 Master lock keys. All the keys have the name Master on them. Some are older then others. Bought at Auction.

 

Kelly Works Flint Edge Axe: 4&1/2lb.True Temper. Made in USA. No chips or cracks. 6&1/2" blade from poll to blade edge. 5&1/4" wide blade. Overall length is 790mm. (31") Older original Han

 

This is a Milwaukee Orbital Sander, Model No. 6012. 120 Volts, 5 amps, 500 watts. Heavy duty industrial quality. Weighs just under 7 lbs. Used it on one project many years ago, an not since. Works per

 

Up for bid is this vintage Brakefix Brake Relining Kit by H&R Products Co. Cleveland Ohio. I believe this kit is complete less parts and instruction sheet. The anvil was ground to make it a little

 

<>TWO STEEL KEY MOLDS/STAMPS<>I have two steel key molds,stamps or dies from a locksmith's collection..The largest one is is 1-3/4"X1-1/4" and 7/8" tall and weighs 3/4 pound..The embossed