Antique woodworking line scribe wood tool with brass clamp bolt measures 7" long by 1 1/8" wide with a 5/8" rabbet back out.

 

For sale here today is a vintage Brown & Sharpe 4 in. surface gage with original box and parts sheet. Model number is 620 B. I listed this as used, but it has hardly been out of the box. There is

 

A selection of vintage hardware that I found today while sorting through the flotsam at the back of the workshop. Dowels Screws, 1000's of Wing Nuts, nails, Masonry Anchors and even a fair dinkum Vint

 

RARE OLD ANTIQUE DRILL BRACE AND ONE FOR PARTS WOOD AND BRASS MADE BY ROB MARPLES HERMITAGE CO 1840.

 

YANKEE No. 41 drill, screw driver, with 10 bits, shows some wear and light rust on finish, works smooth Returns accepted email questions

 

This auction is for an old vintage ring-nose blacksmith tool The tool is used, shows wear but is in good condition. 14-1/4" long. Nice old collectible tool. Comes as seen in pics. Thanks for looking a

 

10 x mixed chisel lot:3 x gouge 3/8's - Hunter & sons, Marples, Mathieson.3/8 Mathieson1/4 ?JB Addis - Flat5/8 Marples.Rober Sorby No.22 Sculpting/Carving(light green handle)Marples Sculpting/Carv

 

Vintage Craftsman Bench Vise 3 5/8" Wide Jaws - 4" to 4 1/8" opening capacity- 180 degree Swivel - works great - holds strong Works Great - Holds very strong- Clean - vise has been disassembled, clean

 

Up for sale is a 1940's vintage, old Craftsman wrench display rack. It will fit 9 wrenches and is marked from 1/4-5/16 up to 1 1/16- 1 1/8. The front shows minimal wear and the back does have small ru

 

Here is yet, another great lot of 8 vintage and newer hammers in different forms for your silversmithing, blacksmithing and general metalworking needs. Using the 1st photo, from left to right, here is